A Shear Operator Helper’s job is to assist the Shear Operator in any and all of the
following job requirements:
Cut jobs for that day as per the schedule,
Check material with drawings to make sure it matches, check quantity of
parts then run material.
Ability to read a tape measure & Micrometer. Accuracy is extremely important
so there is minimal waste from cuttng.
Crane experience is very helpful.
Forklift experience is very helpful.
Non air-conditioned building
The scheduled start time is 6:00 a.m. until the job is done. However, this is
subject to change depending on the Supervisors instructions regarding the job
flow and time constraints for getting certain jobs out. Some early mornings, late
afternoons, and some Saturdays are required.
Apply Now at https://metals2go.com/apply-nondriver/
To apply for this job please visit metals2go.com.