A Shear operator’s job is to cut jobs for that day as per the schedule,
Check material with drawing to make sure it matches, check quantity of parts then run material.
Sizes of material vary from 18ga to ½ plate. Sheet sizes and plate sizes vary from 48”x96” up to 96” to 240”. The weight of materials range from 20 lbs. up to 960 lbs.
Ability to read a tape measure & Micrometer. Accuracy is extremely important so there is minimal waste from cutting.
Crane experience very helpful.
Some Forklift experience required.
Non air-conditioned building
The scheduled start time is 6:00 a.m. until the job is done. However, this is subject to change depending on the Supervisors instructions regarding the job flow and time constraints for getting certain jobs out. Some early mornings, late evenings, and some Saturdays are required.
After our interview, if we are interested we would require the following:
Apply Now at https://metals2go.com/apply-nondriver/
To apply for this job please visit metals2go.com.